The Cost of Driving From Bel Air, Maryland to Richmond Hill, Georgia Based on Current Gas Prices

Are you planning a road trip from Bel Air, Maryland to Richmond Hill, Georgia? Before you hit the road, it's important to know how much it will cost you in gas and tolls. In this blog post, we'll break down the cost of driving from Bel Air to Richmond Hill based on current gas prices.

Route 1: I-95 S

The first route we will look at is taking I-95 S all the way from Bel Air to Richmond Hill. This route covers a distance of 642 miles and should take you around 10 hours depending on traffic.

Gas prices are currently averaging around $2.90 per gallon. With an estimated gas mileage of 28 miles per gallon, you would need around 23 gallons of gas for this trip. This means you can expect to pay approximately $67 for gas each way.

There are no tolls on this route, so the total cost of driving from Bel Air to Richmond Hill using I-95 S is around $134.

Route 2: I-695 S and I-95 S

The second route we'll look at is taking I-695 S to I-95 S. This route covers a distance of 631 miles, which is slightly shorter than the previous route. However, it may take a bit longer due to the two major highways you'll be taking.

This route should take you around 10 hours and 15 minutes depending on traffic. Gas prices are still averaging around $2.90 per gallon, which means you'll need around 22.5 gallons of gas. So, you can expect to pay approximately $65 for gas each way.

There are no tolls on this route either, so the total cost of driving from Bel Air to Richmond Hill using I-695 S and I-95 S is around $130.

Route 3: I-695 S, I-97 S, and I-95 S

The final route we'll look at is taking I-695 S, I-97 S, and I-95 S. This route covers a distance of 672 miles, which is slightly longer than the first and second routes we looked at. However, this route includes some scenic drives through Maryland and Virginia.

This route should take you around 10 hours and 45 minutes depending on traffic. Gas prices are still averaging around $2.90 per gallon, which means you'll need around 24 gallons of gas. So, you can expect to pay approximately $70 for gas each way.

There are no tolls until you hit the George Washington Bridge, which has a toll of $15. So the total cost of driving from Bel Air to Richmond Hill using I-695 S, I-97 S, and I-95 S is around $145.

Conclusion

Based on the current gas prices, the total cost of driving from Bel Air, Maryland to Richmond Hill, Georgia can range from $130 to $145. While there are a few routes you can take, all of them will take you around 10 hours or so to reach your destination.

As always, make sure to check gas prices and toll fees before embarking on your road trip to make sure you're fully prepared for the journey ahead. Safe travels!