The Time it Takes to Drive From Ashburn to Lansdowne

Are you planning to drive from Ashburn, Virginia, to Lansdowne, Virginia, but don't know how long it's going to take? Don't worry; we've got you covered. There are two primary routes to take from Ashburn to Lansdowne. We'll give you the rundown on each, including the distance, estimated drive time at peak traffic and low traffic times, and which route is the fastest and slowest.

Route 1: Waxpool to Riverside

The first route you can take is to drive from Waxpool Road to Riverside Parkway. This route is the shortest distance from Ashburn to Lansdowne, but it can be challenging to navigate due to the traffic. The distance between Ashburn and Lansdowne is just over 6 miles, and at peak traffic times, it can take you up to 25 minutes to get to your destination. During low traffic times, the same route can take around 10 minutes.

Route 2: Belmont Ridge to Route 7

The second route you can take is to head North on Belmont Ridge Road until it intersects with Route 7. This route is longer at almost 8 miles, but it is a faster option, especially during peak traffic times. The estimated drive time between Ashburn and Lansdowne via this route is approximately 12 minutes at peak times. During low traffic times, it's around 8 minutes.

Which is the Fastest Route?

If you're traveling during peak traffic times, the second route (Belmont Ridge to Route 7) is your best bet, even though it's longer than Route 1. The reason for this is that it has multiple lanes for traffic, and that helps with the flow of traffic. On the other hand, if you're driving during low traffic times, Route 1 (Waxpool to Riverside) can be the fastest route as it is the shortest distance.

Which is the Slowest Route?

Route 1 is the slower of the two routes, taking between 10-25 minutes, depending on the traffic. This is because at peak traffic times, the road can get congested. A good tip is to avoid using this route during rush hour and peak traffic times.

The Verdict

In conclusion, the time it takes to drive from Ashburn, Virginia, to Lansdowne, Virginia, depends on the route you take and the traffic conditions. If you're driving during peak traffic times, take Route 2 (Belmont Ridge to Route 7), which is longer but is often faster due to its multiple lanes. For low traffic times, Route 1 (Waxpool to Riverside) is the shortest distance and can be the fastest route. However, make sure you factor in peak traffic times when making your decision. Whatever route you take, allow extra time for unexpected delays, and always drive safely!